Are you doing your own plumbing for the first time? You probably don’t even know where to start. It’s no secret that doing your own plumbing for the first time can be a bit overwhelming. Below are some tips that can help to make maintaining your own plumbing a bit smoother.

You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.

Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.

Have your septic tank cleaned every five years to keep it in prime condition. Having it cleaned out prevents the sediment from accumulating in the septic tank and creating a sewage backup in your house or triggering the meltdown of the entire septic system. It may be a bit expensive to pump a septic tank, but it will be very expensive to clean up an emergency sewage problem.

Use a hairdryer to thaw frozen pipes, after you shut off the water to the house. A hairdryer will gently heat the pipe and thaw the ice without causing significant damage to the pipe. Shutting off the water first means that if the pipe is broken, there will be no rush of water into the house.

Check how well your toilets are flushing. If the handle needs to be played with in order to keep the water from running constantly, or if it needs to be held down several times in order to flush, you may need to switch out some of the parts in your tank. This is not expensive, and it could help reduce your monthly water bill. It could also mean that you avoid the embarrassment of the flushing system breaking when you have visitors!

An incorrectly installed hose from the kitchen sink to the dishwasher can cause unwanted water to drain into the dishwasher. This hose should lead uphill first and then downhill so the water from the sink and the dishwater never mix.

Many people deal with clogged toilets. However, if your toilet will not flush every time, the water rises to the top, and there is bubbling effect occasionally, this can be due to a much deeper blockage in the main pipe. The main pipe must then be cleaned in order for your toilet to work properly.

Have your pipes in your plumbing system frozen? You can skip the cost of hiring a md sewer plumber by using this method. First, open the faucet so steam produced by the thawing process can escape. Begin thawing close to the faucet, and move down the line as each section thaws out. Use a hair dryer or a heat lamp to warm along the pipe. Even though this method consumes quite a bit of time, it is safer than most other heating methods. Furthermore, it requires no cleanup.

As you have seen, doing your plumbing is not as scary as it may appear at first. Just think of all of the benefits it has and all of the expenses it can take care of, along with all of the money it can save you in the long run.

Leave a Reply

Your email address will not be published.